| Security Protective Coatings, Inc. Rusty metal roof restoration |
| Typical rusty metal roof before restoration. |
| All screws are tightened. Any stripped screws are replaced. |
| The roof is power washed with commercial high pressure 4,000psi pressure washers, using a special 0 degree oscillating orbital tip. This blasts off all loose paint, debris, and rust scale. |
| Screws and bolt heads are buried in a thick layer of urethane rubber paste. This permanently seals them against leaks. |
| After all preparations have been completed, a variety of finish coats are applied, depending on building requirements and budget. Coatings range from a low cost fibered asphaltic aluminum, to the premium synthetic rubbers, (acrylic, urethane, silicone) giving the owner many years of reliable warrented service. |
| SPC, Inc. P.O. Box 952 West Bend, WI 53095 Phone 262-338-2999 |
| . |
| l |
| l |
| l |
| l |
| l |
| Vertical ribs, where ice damming is often a problem, are also sealed with the heavy urethane rubber paste. |
| Horizontal seams and ridge caps are also sealed with the urethane paste to prevent wind driven rain from being forced inside. |
| All roof penetrations are completely sealed with a heavy layer of urethane rubber paste to create new rubber flashings. |
| Crushed or cracked ribs are covered with a self adhesive rubber tape, then sealed with the urethane rubber paste. |
| After an appropriate primer is applied (where needed) a thick layer of synthetic rubber is applied to the roof. |
| SPC, Inc. P.O. Box 952 West Bend, WI 53095 Phone 262-338-2999 |
